Application report - Representation of the cooling process with stationary stroboscopes RT STROBE 5000 LED


At an exhibit, the cooling process on an up-turning CNC milling machine should be visualized.

As on the application, besides the spray mist also further influences through extraneous light and a high viscous fluid, which can build up on the glass of the exhibit, a special focused and high-frequent solution was necessary.

In details The spindle in the middle reaches a rotation up to 18,000 rpm, and is being flowed by a cooling fluid.

This fluid process should be made visual with a stroboscope. A PLC is being used which sends a trigger signal to adapt rates to the speed.  



Using the RT STROBE 5000 LED stationary stroboscope, the complete web width can be illuminated effortlessly.

As a result, the complete cooling process on the up-turning CNC milling machine is visualized.

The flash rate up to 120,000 FPM (flashes per minute) as well as the light intensity of the single flash which is approx. 1.0 Mega LUX were the main reasons for the purchase decision according to the customer Wanner Elektrotechnik GmbH.

The extremely high light intensity of the RT STROBE 5000 LED is guaranteed by 120 high-power LEDs.

The large, homogeneous illumination surface delivers superb results even at difficult light conditions, making the RT STROBE 5000 LED suitable for a very wide range of measurement, observation and inspection functions. 

The full report can be downloaded here: